Mopar K6860899 - Manual (Page 5)

4
20. Install the WiFi router cradle (2) to the rear cab trim
panel (1) with the provided materials.
21. Make a small cut in the rear cab trim panel and route
the WiFi router connector through
22. Place the rear cab trim panel into position in the vehi­
cle.
23. Connect the wire harness to the WiFi router connec­
tor.
24. Route the wire harness down the back of the rear
panel to the door sill.
25. Firmly seat the rear panel and install the utility hooks
to the rear panel.
26. Continue to route the wire harness along the passen­
ger side, under the glove box opening and behind the
center stack and cut to the proper length.
27. Locate the cigarette lighter outlet wiring harness.
28. Cut each wire and remove 13 mm (0.5 in.) of insula­
tion from each wire that needs to be soldered/spliced.
29. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol­
dered area.
CAUTION: Do not use acid core solder.
30. Solder the supplied fused pigtail to Wi­Fi power har­
ness power wire (RD/LG).
31. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009 K6860899 Rev. 1