Mopar K6860899 - Manual (Page 57)

7
32. Position the quarter trim panel in the vehicle.
33. If equipped, connect the wire harness connector to the
power outlet.
34. Position the flange on the quarter trim panel into the
seal ditch and secure the bottom clip first and then the
middle clip.
35. Align the two fastener holes in the quarter trim panel
with the two fastener holes in the quarter panel and
engage the retaining tabs that secure the quarter trim
panel to the quarter panel.
36. Install the two screws that secure the quarter trim
panel to the quarter panel.
37. Position the load floor in the vehicle. Route the twisted
pair wire harness (2) through the bottom of the floor
and connect the harness to the Wi­Fi Router connec­
tor.
38. Install the two nuts that secure the load floor to the
floor panel.
39. Using the supplied self­tapping screws, secure the
Wi­Fi Router bracket (1) to the load floor.
40. Install the D­pillar trim panel. Position the locating tabs
on the bottom of the D­pillar trim panel into the slots
in the top of the quarter trim panel.
41. Align the retaining tabs on the D­pillar trim panel with
the retaining clips in the D­pillar and engage the re­
taining tabs that secure the trim panel to the D­pillar.
Oct 16, 2009 K6860899 Rev. 1