Mopar K6860899 - Manual (Page 74)

1
WI­FI ROUTER
DODGE NITRO, JEEP LIBERTY
PROCEDURE STEPS:
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two
minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the
only sure way to disable the airbag system. Failure to follow these instructions may result in possible serious
or fatal injury.
NOTE: Using a test light, verify the cigarette lighter outlet being used is ignition switched. Power must not be
present with the ignition in the OFF position.
1. Set the park brake and move the transmission gear
selector into the most rearward position.
2. Using trim stick C­4755 or equivalent and starting at
the top of the center bezel, pry the bezel away from the
instrument panel far enough to disengage the snap
clip retainers securing it to the instrument panel.
3. Reach behind the bezel to access and disconnect all
electrical connections.
4. Remove the center bezel from the instrument panel.
5. Disconnect and isolate the negative battery cable.
6. Remove the fasteners and the passenger side close
out panel from the lower I/P.
7. Open the glove box.
8. While squeezing the stop tabs located on the sides,
swing the glove box door open.
9. With the glove box in the full down position, slide the
glove box to the right, off of the hinges and remove.
Oct 16, 2009 K6860899 Rev. 1
PRINT THIS VEHICLE INDEX