Avaya C360 - Manual (Page 163)

IP Configuration
Issue 1 July 2006 163
Assigning Initial Router Parameters
To configure the initial router parameters perform the following via the CLI:
1. Type set device-mode router and press Enter.
You will be prompted to reset the switch.
2. Type y.
Wait for the switch to restart and for the CLI prompt to reappear.
3. Type show device-mode and press Enter to ensure that the module is in router mode.
Tip:
Tip:
Assign the stack IP address as described in Assigning C360 IP Stack Address on
page 64 before you assign the Initial Router IP address.
4. To access Router commands from the Master module, type the command session
<module number> router where <module number> is the location of the router
module in the stack, and press Enter.
The command prompt changes from C360-N> to Router-N#> where N is the number of
the router in the stack (see
SNMP Support ).
5. Type configure and press Enter. The prompt Router-N(configure)# appears.
Specify the VLAN on which an
IP interface resides ip vlan/ip vlan name
Use this command before
configuring VLAN-oriented
parameters, when there is more
than one interface on the same
VLAN enable vlan commands
Display information about the IP
unicast routing table show ip route (Layer 3)
Display information for an IP
interface show ip interface
Display the status of ICMP error
messages show ip icmp
Delete a Layer 2 Router
interface clear vlan
In order to... Use the following command...
2 of 2