Avaya C360 - Manual (Page 78)

Establishing Switch Access
78 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Configure the SNMPv3 engine
ID snmp-server engineID
Return the SNMPv3 engine ID
to its default value no snmp-server engineID
Create an SNMPv3 user snmp-server user
Remove an SNMPv3 user no snmp-server user
Create an SNMPv3 group snmp-server group
Remove an SNMPv3 group no snmp-server group
Create a view or add or exclude
OIDs from a view snmp-server view
Delete an SNMPv3 view no snmp-server view
Set a read/write/trap SNMPv1
community name set snmp community
Display a list of SNMPv3 views show snmp view
Display a table of SNMPv3
users and the groups with which
they are mapped show snmp userToGroup
Display the SNMPv3 engine ID show snmp engineID
Display a list of SNMPv3 groups show snmp group
Display a list of SNMPv3 users show snmp user
Display a list SNMPv3
notification receivers and
SNMPv1 trap receivers show snmp
Enable or disable link up/link
down notifications and traps set port trap
Define SNMPv1 trap receivers
or configure the SNMPv1 traps
sent by the device set snmp trap
Removes SNMPv1 trap
receivers clear snmp trap
Enable or disable SNMPv1 traps
for authentication failures set snmp trap enable/disable
auth
Table 16: SNMP CLI Commands 2 of 3
In order to... Use the following command...
2 of 3