Avaya C360 - Manual (Page 68)

Establishing Switch Access
68 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Figure 21: SSH Session Establishment Process
Procedure for Establishing an SSH Connection
Perform the following steps to establish an SSH connection to the C360 for configuration of
Stack or Router parameters. You can open an SSH session to the Stack Master IP address:
1. Use the show ip ssh CLI command to ensure that an SSH key has been generated on
the switch.
- Use the crypto key generate dsa CLI command to generate a key if necessary.
2. Enable SSH on the switch using the ip ssh enable CLI command.
3. Connect your station to the network.
4. Verify that you can communicate with the C360 using Ping to the IP of the C360. If there is
no response using Ping, check the IP address and default gateway of both the C360 and
the station.
- The C360 default IP address is 149.49.32.134 and the default subnet mask is
255.255.255.0.
Username List
HOST RSA Key
Hostnames List
Initiate CLI Session
User Passwords
User Authentication
SSH Client Connection
Public Key and Encryptions List
Establish Connection
Private Key and Encryptions List
Acknowledgement (ACK)
SSH
Server