Avaya C360 - Manual (Page 91)

Issue 1 July 2006 91
Chapter 6: Avaya C360 Default Settings
This section describes the procedures for the first-time configuration of the C360. The factory
defaults are set out in detail in the tables included in this chapter.
Configuring the Switch
You may configure the C360 using the text-based Command Line Interface (CLI), the built-in
C360 Device Manager or Avaya Integrated Management.
For instructions on the CLI, see the Reference Guide for the Avaya C360 Converged Stackable
Switch, 10-300506.
For instructions on the use of the graphical user interfaces, refer to the C360 Device Manager
User Guide on the Avaya C360 Documentation and Utilities CD.
C360 Default Settings
The default settings for the C360 switch and its ports are determined by the C360 firmware.
These default settings are subject to change in newer versions of the C360 firmware. See the
C360 Release Notes for the most up-to-date settings.
Table 21: Default Switch Settings 1 of 2
Function Default Setting
IP address 149.49.32.134
Subnet Mask 255.255.255.0
Default gateway 0.0.0.0
Management VLAN ID 1
Spanning tree Enabled
Bridge priority for Spanning Tree 32768
Spanning tree version Common spanning
tree
1 of 2