Avaya C360 - Manual (Page 168)

Avaya C360 Layer 3 Features
168 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
OSPF CLI Commands
In order to... Use the following command...
Enable OSPF protocol router ospf
Configure the area ID of the
router area
Configure router identity ip ospf router-id
Configure a passive ospf
interface passive-interface
Redistribute routing information
from other protocols into OSPF redistribute
Configure the delay between
runs of OSPF's SPF calculation timers spf
Configure interface metric ip ospf cost
Specify the time interval
between hellos the router sends ip ospf hello-interval
Configure the interval before
declaring the neighbor as dead. ip ospf dead-interval
Configure interface priority used
in DR election ip ospf priority
Configure the interface
authentication password ip ospf authentication-key
Display general information
about OSPF routing show ip ospf
Display the OSPF-related
interface information show ip ospf interface
Display OSPF neighbor
information on a per-interface
basis show ip ospf neighbor
Display lists of information
related to the OSPF database
for a specific router show ip ospf database
Configure an interface as
passive passive-interface