Avaya C360 - Manual (Page 141)

RMON
Issue 1 July 2006 141
● The Group Filtering Delay time is the time that the switch waits between becoming aware
of a Multicast group on a certain VLAN and starting to filter traffic for this group.
IP Multicast CLI Commands
The following table contains a list of the CLI commands for the IP Multicast feature. The rules of
syntax and output examples are all set out in detail in the Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
RMON
RMON Overview
RMON, the internationally recognized network monitoring standard, is a network management
protocol that allows network information to be gathered at a single workstation. You can use
RMON probes to monitor and analyze a single segment only. When you deploy a switch on the
network, there are additional components in the network that cannot be monitored using
RMON. These components include the switch fabric, VLAN, and statistics for all ports.
In order to... Use the following command...
Enable or disable the IP
multicast filtering application set intelligent-multicast
Define aging time for client ports set intelligent-multicast client
port pruning time
Define aging time for router
ports set intelligent-multicast router
port pruning time
Define group filtering time
delays set intelligent-multicast
group-filtering delay time
Display the status IP multicast
filtering application show intelligent-multicast
Shows whether the connected
unit's hardware supports IP
multicast filtering show intelligent-multicast
hardware-support