Avaya C360 - Manual (Page 191)

Power Over Ethernet
Issue 1 July 2006 191
Power over Ethernet CLI Commands
In order to... Use the following command...
Perform a hardware reset of
the switch and the PoE circuitry
reset module-and-powerinline
Perform a hardware reset of
the entire stack and the PoE
circuitry
reset stack-and-powerinline
Enable the load detection
process and power delivery for
the port
set port powerinline enable
Disable the load detection
process and power delivery for
the port
set port powerinline disable
Configure the priority level of
powering the port.
set port powerinline priority
Set the type of powered device
connected to the PoE port.
set port powerinline type
Configure PoE traps and the
consumption usage threshold
value.
set powerinline trap
Show the current status of the
PD inline power on all ports
show powerinline