Avaya C360 - Manual (Page 69)

Establishing an SSH Connection
Issue 1 July 2006 69
5. Using your SSH client software, open a session to the Stack Master IP address.
6. When you are prompted for a password, enter the User Level password root in lower case
letters (do not use uppercase letters).
- The User level prompt will appear when you have established communications with the
C360. You can now configure the C360 stack and change its default IP address.
SSH Commands
The following SSH commands are accessible from Supervisor level.
Table 15: SSH CLI Commands
In order to... Use the following command...
Enable SSH and configure SSH
parameters ip ssh enable
Disable the SSH server no ip ssh
Display active SSH sessions on
the device. This command is
only available from the master
module switch context and from
all router contexts. show ip ssh
Disconnect an existing SSH
session. If an SSH session was
entered from the router, it can
only be disconnected from
router mode. disconnect ssh
Generate an SSH host key pair crypto key generate dsa