Avaya C360 - Manual (Page 86)

Establishing Switch Access
86 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Allowed Protocols
Allowed Protocols Introduction
With the Allowed Protocols feature, the network manager can determine the IP protocols
enabled on the switch. This feature can be used to block access to the switch using specific IP
protocols. Each protocol can be independently enabled or disabled on the switch.
Tip:
Tip:
Enabling and disabling the Recovery Password protocol can only be done using
a direct console connection via the Console port.
Allowed Protocols CLI Commands
The following Allowed Protocols commands are available.
Table 20: Allowed Protocol CLI Commands 1 of 2
In order to... Use the following command...
Enable Telnet on the switch ip telnet enable
Disable Telnet on the switch no ip telnet
Enable HTTP on the switch ip http enable
Disable HTTP on the switch no ip http
Enable the switch agent to
accept ICMP redirect packets
sent to it ip icmp redirect
Enable the switch agent to
ignore ICMP redirect packets
sent to it no icmp redirect
Enable SNMP on the switch snmp-server
Disable SNMP on the switch no snmp-server
Enable SNMPv1 switch access snmp-server community
Disable SNMPv1 switch access no snmp-server community
1 of 2