Aiwa NSX-999 - Manual (Page 52)

RECORDING
r
2
3
1 ....- .f .. - .—.........
1 r . = ■
■ r
■ !
6 6 ; ' i . f - - -
------)
1
......
RECORDING FROM A CD
Preparation
• Wind up to the point where recording wiii start.
• Use normal (type I) or Cr02 (type II) tapes.
1 Insert the tape to be recorded on into deck 2.
Press the EJECT ± . mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
2 Set DOLBY NR.
To record with DOLBY NR: Press the DOLBY NR button to turn
on the Dolby NR. The □□ NR indicator will light.
To record without DOLBY NR: Press the DOLBY NR button to
turn off the Dolby NR. The □□ NR indicator will go off.
3 Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on
To record on both sides, turn on ^3.
4 Press the CD button.
5 Load discs onto the disc trays.
The disc loaded on tray 1 is played first.
6 Press the • REC/REC MUTE button to start record­
ing.
Playing and recording start simultaneously with the first track of
the first disc. All discs in the compartment are recorded if the
tape is long enough.
When you use the remote control to start recording, first press
the 0/0 REC/REC MUTE button and then press the
button within 2 seconds.
To stop recording from the CD
Press the ■ button to stop the deck, and press it again to stop the
CD player.
After play stops at the end of the CD
Deck 2 enters recording stop mode.
To record selected tracks
Before pressing the • REC/REC MUTE button, program the
tracks. (See “PROGRAMMED PLAY”.)
To record part of the CD
When the • REC/REC MUTE button is pressed, recording always
starts from the first track. To start in the middle of a track, play the
CD up to the point where you want to start recording, and then press
the • REC/REC MUTE button.
52