Aiwa NSX-999 - Manual (Page 76)

TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these operating instruc­
tions, check the foliowing guide.
GENERAL
There is no sound.
• Is the AC cord connected properly?
• Is there a bad connection?
Sound is emitted from one speaker only.
• is the other speaker disconnected?
The output sound is not stereo.
• is the KARAOKE function turned on?
CD PLAYER SECTION
The CD does not play.
• is the disc correctiy inserted?
• Is the disc dirty?
• Is the lens affected by condensation?
-► Wait approximately one hour and try again.
CASSETTE DECK SECTION
The tape does not run.
• Is the deck in pause mode? (deck 2)
The sound is off-balance or not adequately high.
• Is the playback head dirty?
High sounds are too loud.
• Is the DOLBY NR mode set differently from when the recording
was made?
There are no high sounds.
• Is a tape recorded without Dolby NR being played back in Dolby
NR mode?
• Is the playback head dirty?
Recording is not possible.
• Is the erasure prevention tab on the tape broken off?
• Is fhe recording head dirty?
Erasure is not possible.
• Is the erasure head dirty?
• Is the metal tape being used?
TUNER SECTION
There is constant, wave-like static.
• Is the antenna connected properly?
• Is the signal weak?
Install an outdoor antenna.
The reception is noisy or the sound is distorted.
• Is the unit picking up external noise or multipath distortion?
-► Change the orientation of the antenna.
-► Move the unit away from other electrical appliances.
To reset
If an unusual condition occurs in the display window or the cassette
deck, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button while pressing the ■ CLEAR button.
Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and repeat step 2.
76