Avaya P460 - Manual (Page 114)

Chapter 2 Avaya P460 CLI Commands
104 Avaya P460 Reference Guide
necessary.
Use the set qos dscp-cos-map command to configure the DSCP table.
The syntax for this command is:
set qos dscp-cos-map <dscp1>[-<dscp2>] <operation>
[<precedence>]
Example:
set qos dscp-name
User level: read-write, admin.
L You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-name command to configure the DSCP entry name.
The syntax for this command is:
set qos dscp-name <dscp> <name>
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
dscp1 dscp range min (0-63)
dscp dscp range max (0-63)
operation fwd0-7 | no-change
precedence mandatory | optional
Router-1(configure)# set qos dcsp-cos-map 9-16 fwd3
dscp1 dscp entry (0-63)
name entry name
Router-1(configure)# set qos dscp-name 10 special