Avaya P460 - Manual (Page 88)

Chapter 2 Avaya P460 CLI Commands
78 Avaya P460 Reference Guide
set interface inband
User level: read-write, admin.
Use the set interface inband command to configure the inband interface on
the Supervisor Module.
The syntax for this command is:
set interface inband <vlan> <ip_addr> <netmask>
Example:
To configure the inband interface on VLAN 1, IP address 1.1.1.1 and netmask
255.255.255.24:
set interface outband
User level: read-write, admin.
Use the set interface outband command to configure the outband interface
on the supervisor Module.
The syntax for this command is:
set interface outband <ip_addr> <netmask>
vlan The number of the VLAN to be assigned to the interface
ip_addr IP address
netmask Subnet mask
P460-1# set interface inband 1 1.1.1.1 255.255.255.24
This command will RESET the device
*** Reset *** - do you want to continue (Y/N)? y
ip_addr IP address
netmask Subnet mask