Avaya P460 - Manual (Page 39)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 29
enable vlan commands
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
L Use the enable vlans commands command before configuring VLAN-
oriented parameters, when there is more than one interface on the same VLAN.
The syntax for this command is:
enable vlan commands
Example:
get time
Use the get time command to retrieve the time from the network.
The syntax for this command is:
get time
Example:
hostname
User level: read-write, admin.
Use the hostname command to change the Command Line Interface (CLI)
prompt. The current module number always appears at the end of the prompt.
Use the no hostname command to return the CLI prompt to its default.
The syntax for this command is:
[no] hostname [<hostname_string>]
Router-1(config-if:marketing)#enable vlan commands
P460-1> get time
Time is being acquired from server 0.0.0.0
Time has been acquired from the network.
hostname_string • none – displays current hostname
• string – the string to be used as the hostname (up to 20
characters).