Avaya P460 - Manual (Page 70)

Chapter 2 Avaya P460 CLI Commands
60 Avaya P460 Reference Guide
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the network command to enable OSPF in this network.
Use the no network command to disable OSPF in this network.
The default is disabled.
The syntax for this command is:
network <net addr> [<wildcard-mask> [area <area id>]]
Example:
no rmon alarm
User level: read-write, admin.
Use the no rmon history command to delete an existing RMON alarm entry.
The syntax for this command is:
no rmon alarm <Alarm Index>
net addr IP address
wildcard-mask Wildcard mask address
area id Area ID. This parameter exists for compatibility with
P550.
Router-1 (configure router:ospf) # network 192.168.0.0
Router-1 (configure router:ospf) # area 192.168.0.0
0.0.255.255 area 0.0.0.0
Alarm Index History index defined using rmon alarm command or P460
Manager.
P460-1# no rmon alarm 1026