Avaya P460 - Manual (Page 128)

Chapter 2 Avaya P460 CLI Commands
118 Avaya P460 Reference Guide
set vlan (Layer 3)
User level: read-write, admin.
L You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set vlan command to create a router Layer 2 interface.
The syntax for this command is:
set vlan <vlan-id> name <vlan-name>
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
set web aux-files-url
User level: read-write, admin.
Use the set web aux-files-url command to allow the Device Manager to
automatically locate the URL of the Web server containing the Device Manager help
files and Java plug-in.
Tip: Ensure that the Web server is always accessible to prevent potential delays to
Web access to the device.
The syntax for this command is:
set web aux-files-url <//IP address/directory name>
Example:
If you wish to define a directory name which includes spaces, you must enclose the
vlan-id Interface Index
vlan-name Interface name (used in layer 3 protocols)
Router-1(configure)# set vlan 2 name vlan2
P460-1# set web aux-files-url //192.168.47.25/emweb-aux-
files