Avaya P460 - Manual (Page 173)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 163
show port trap
User level: read-only, read-write, admin.
Use the show port trap command to display information on SNMP generic
link up/down traps sent for a specific port.
The syntax for this command is:
show port trap [<module>[/<port>]]
Example:
module
(Optional) Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port
(Optional) Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
P460-1> show port trap 4/1
Port 4/1 up/down trap is disabled