Avaya P460 - Manual (Page 61)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 51
Example:
ip route
User level: read-write, admin.
L You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip route command to establish a static route.
Use the no ip route command to remove a static route.
The syntax for this command is:
[no] ip route <ip-address> <mask> <next-hop> [<next-hop>]
[<next-hop>] [<cost>] [<preference>]
Example:
To define the router 192.168.33.38 as the next hop for the network 192.168.33.0 with
mask 255.255.255.0:
ip routing
User level: read-write, admin.
L You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode.
Router-1(configure-if:marketing) # no ip rip split-horizon
Done!
ip-address The IP address of the network
mask Mask of the static route
next-hop The next hop address in the network
cost The path cost. The default is 1
preference Preference, either High or Low. Default is Low.
Router-1(configure)# ip route 192.168.33.0 255.255.255.0
10.10.10.10