ADLINK PCI-8102 User Manual
Page 129
118
Function Library
Motion Interface I/O Section 6.12
Interrupt Control Section 6.13
Function Name
Description
_8102_set_servo
Set On-Off state of SVON signal
_8102_set_pcs_logic Set PCS signal’s logic
_8102_set_clr_mode Set CLR signal’s mode
_8102_set_inp
Set INP signal’s logic and operating mode
_8102_set_alm
Set ALM signal’s logic and operating mode
_8102_set_erc
Set ERC signal’s logic and timing
_8102_set_sd
Set SD signal’s logic and operating mode
_8102_enable_sd
Enable SD signal
_8102_set_limit_logic Set EL signal’s logic
_8102_set_limit_mod
e
Set EL operating mode
_8102_get_io_status Get all the motion I/O status of 8102
Function Name
Description
_8102_int_control
Enable/Disable INT service
_8102_wait_error_interrupt Wait error related interrupts
_8102_wait_motion_interru
pt
Wait motion related interrupts
_8102_set_motion_int_fact
or
Set the factors of motion related interrupts
_8102_wait_gpio_interrupt Waiting GPIO interrupts
_8102_set_gpio_int_factor
Set the factors of general purpose IO
related interrupt