East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 12)

•
With belt in place, install pre assembled ac
tensioner (fig 33) as shown and tighten.
•
Use a 15mm socket to unload tensioner and
replace AC belt.(fig 33)
•
Reinstall Rack and pinion, brake lines, PS lines, tie rods ends, and steering knuckle to factor torque
specifications. All electrical connections associated with the rack and pinion can now be re attached. Re
tighten the 4 - 21mm nuts supporting front engine cradle.
•
On the passenger side of the radiator support
cradle, measure 2 inches up from weld, on the
forward support leg as shown. Mark and drill
a hole with supplied Q drill bit to accept
supplied rivet nut. This rivet nut will be used
later to remount horn assembly. (fig 34)
•
To set rivet nut in cradle, install supplied rivet nut
into the previously drilled hole, and insert
supplied ¼ in allen bolt with nut as shown.
Holding allen wrench in bolt, turn 11mm nut
clockwise to compress rivet nut inside radiator
support frame. (fig 35)
33
34
35
Install supplied 3/8” thick washer on the AC
tensioner pulley bolt as shown in picture to
the left.
With AC belt still in place, install the
preassembled AC tensioner and the main
tensioner bracket at the same time using the
new supplied 8mm bolt to tighten the AC
tensioner in place. (fig. 33)
33
shaft to factory torque