East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 33)

•
With fuel line removal tool, remove braided fuel line on drivers side fuel rail.
•
Remove fuel rail from intake manifold,
pulling injectors from manifold. (fig 90)
•
Using a screwdriver, slide injector retaining
clips off injectors and remove stock injectors
from rail. Using a small screwdriver or pick
tool, carefully remove bottom o-rings from
supplied Motron 60’s, and replace with
supplied (brown) o-rings. (This is necessary
with all Motron injector applications). Be
careful not to damage o-ring or injector
during this process. (fig 91)
•
Use WD-40 (or equivalent) to lubricate o-rings
(both o-rings), and install injectors into fuel rail.
Reinstall injector retaining clips on all injectors
and seat fuel rail back on car, installing aluminum
spacers and lock washers as shown (10mm
socket). Apply pressure on fuel rail above each
injector to ensure all injectors are seated properly.
Use caution not to pinch or damage o-rings during
this process. (fig 92)
•
Install provided injector adapter harness’
between injector and factory injector plugs.
Using a small screwdriver, depress each
injector harness plug, as shown until an
audible ‘click’ is heard. This locks the harness
on the factor injector plug.
•
Reinstall fuel line and fuel line retaining clip.
Reconnect the 4 factory harness clips to fuel rail.
90
91
92
93