East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 30)

•
At this point go back under the car, and tighten
the worm clamps on the 3 inch rubber coupler
that attaches the intercooler to the U tube.
(fig 80)
•
Attach plastic inlet tube to air filter as shown, (fig
81) being sure that the aluminum restrictor plate is
in place (restrictor plate is recommended in stock
applications. DO NOT remove restrictor plate
with out supporting modifications or engine
damage can occur)
•
Install inlet duct, filter end first then pulling back
and attaching directly to blower with 10mm worm
clamp. (fig 82)
•
Remove vacuum hose from brake booster, cutting
at shown. (figs 83, 84) Install supplied vacuum T
fitting tightening with supplied ½ in worm
clamps. These vacuum fittings will be used for
your kits blow off valve and boost a pump.
•
Install supplied 5/32nds hose on the forward
vacuum barb fitting and run line around master
cylinder and down drivers side inner fender well to
vacuum fitting on blow off valve. Use supplied zip
ties to secure line away from any heat sources or
moving parts, being careful not to pinch or puncture
line. (fig 84)
82
80
81
83
84
t-bolt