East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 23)

•
Install 2 nd
head unit spacer on the previously
installed lower passenger side 3/8ths bolt as
shown. (fig 63)
•
Install the two remaining 3/8ths studs and head
unit spacers to head unit and mounting bracket
with supplied washers and lock nuts as shown.
(fig 64)
•
Tighten ALL Head unit/bracket hardware.
•
On top of head unit, remove top plug and install the
head unit vent with a 3/16ths allen wrench.
•
Your head unit was pre-filled from the factory, but take
a moment to check for proper oil level by removing the
dipstick – located on the passenger side of the head
unit right below the vent plug. (fig 64 see arrows)
•
•
Install the passenger side upper radiator support
bracket with the 10mm factory radiator support
bolts. (fig 65)
•
Reinstall alternator with factory hardware (15mm
socket), being sure to reinstall electrical plug and
main power feed on back of alternator (13mm
nut).
63
64
65