East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 34)

ECS Fuel Pump Booster Instructions C6
Locate wiring harness going to fuse box. It should have blue tape wrapped around the plastic loom, find the
heavy GRAY wire on either side of the connector.
Cut the heavy GRAY wire on either side of the connector leaving enough room to strip the wire for the new
connector.
Mounting of ECS bap is really up to the installers imagination the following are just general guidelines:
Dry Sump Car: Mount ECS bap in the inner fender by the oil reservoir
Wet Sump Car: Mount ECS bap next to the battery on the inner fender
Now on the ECS bap locate the red wire with the fuse attached, using the supplied connectors run that wire to
the end of the heavy GRAY wire going toward the fuse box.
Attach the ORANGE wire from the ECS bap to the other end of the heavy GRAY wire going toward the fuel
pump.