East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 16)

•
Install bracket with supplied ¼ in bolts and
washers. (fig 44)
•
From left edge of installed bracket measure
13 inches to right and mark support with a
line to guide installation of right side
intercooler support bracket. Place the
intercooler support bracket against line as
shown, mark holes and drill frame (with the
supplied Q bit), to accept rivet nuts. Insert
rivet nuts into holes and set in place
following the same procedure as left side
support. (fig 45)
•
From the top of the car, set intercooler assembly in
intercooler brackets being sure that rubber
grommets are centered in lower brackets. BOV
should on drivers side of the car. From the bottom
of the car insert the supplied 3/8 x ¾ long bolts with
washers securing the intercooler into the lower
brackets. (fig 46)
•
With a 10mm ratchet, remove the two
front fascia mounts from both sides of
radiator support cradle, as shown. (pic).
These will not be reused.
44
45
46
47