East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 15)

•
Place lower radiator hose on workbench, and cut
hose in middle as shown. Install supplied worm
clamps and insert the supplied radiator hose
extension pipe into hose as shown. Tighten top
worm clamp, leaving lower portion loose until
reinstallation in car. (fig 40)
•
Set radiator and AC condenser into lower
radiator support mounts, and reinstall
lower radiator hose. Be sure to tighten
lower worm clamp and re spring clamps at
this point. (fig 41)
•
Taking one intercooler support bracket, measure ½
in from radiator cradle mounting tab. Mark holes
and drill radiator support bracket with supplied Q
drill bit. The support is hollow. You only need to
drill through back side of support, not all the way
through the tubing. (fig 42)
•
Install supplied rivet nuts into holes, and insert
supplied ¼ in allen bolt with nut as shown.
Holding allen wrench in bolt, turn 11mm nut
clockwise to compress rivet nut inside radiator
support frame. (fig 43)
40
41
42
43