East Coast Supercharging ECS Paxton SC1500 C6 Supercharger Kit - Manual (Page 2)

ECS SC 600 Instructions (C6)
These instructions are meant to serve as a guide to the installation of the ECS SC600 Supercharging kit. Please
be sure to use all safety equipment including gloves, and eye protection. Please use proper techniques to capture
and dispose of, or reuse factory fluids. Utilization of the proper tools will make the install smoother and faster.
If you are having ECS provide you with a start up tune, your first step should be to remove your PCM, and ship
immediately so that you can have it back ready for start up. Our shipping address is 562 Rt. 539, Cream Ridge,
NJ, 08514.
Installation should take between 12 and 20 hours for a qualified mechanic. Do not rush the install. If need
technical support please call the shop at 609-752-0321.
ECS SC600 Kit Installation:
•
Remove fuel Rail covers, and disconnect battery terminals with 10 MM wrench.
•
Remove cap from coolant reservoir and proceed to drain coolant by turning radiator drain cock one ¼
turn to the left.
•
Remove stock serpentine bet by placing
15mm wrench on tensioner bolt and press
towards intake and pulling bet forward off
tensioner
•
Remove stock tensioner by removing the 2
15mm bolts with socket. Save bolts for later
use.
•
Remove hard plastic vacuum line from
passenger side valve cover (Fig.1)
•
Remove 15 mm bolt and bracket holding Evap solenoid
to passenger side head and discard. Evap solenoid stays
in place. (Fig.2)
•
On the drivers side of the car, remove alternator wiring
harness from top of alternator and positive alternator wire
by removing 13mm retaining nut. Remove 2 - 15mm
bolts on the front of bracket and remove alternator from
car.
•
Remove stock air bridge and filter assembly from car by
loosening clamps and pulling forward and up off throttle
body.
1
2
belt
Disconnect MAF and then remove stock air bridge and
filter assembly from car by loosening clamps and pulling
forward and up off throttle body.