Laerdal VitalSim - Manual (Page 17)

17
To start a scenario, press the Scen button.
Note: It usually takes a little time to transfer all of the scenario
information to the remote control.
Select the desired scenario and press OK.
The scenario will start with the clock set to 0 and a new log
will begin.The current log will be erased, unless it is saved
before the scenario is started.
When running a scenario the top line of the main display
shows the scenario name and number of the current frame.
Pause. Stops the clock and scenario execution. Any events
or changes in settings will not be logged or affect the scenario.
Resume logging and scenario execution.
Restart the scenario. Erase current log and restart logging.
Stop scenario execution. Logging and clock will continue in
normal operation.
Scenario Events
When running a scenario, the Log Events are replaced with
Scenario Events that are programmed individually for each
scenario. Scenario Events are programmed in the PC Scenario
Builder program.
Selected events will go into the log, and can also be used as
events in the scenario, bringing the scenario from one frame
to the next.
To select a Scenario Event, press the Event quick execution
button. Select the event from the menu using the arrow
buttons, and press OK.
New VitalSim DfU En 6/14/05 4:18 PM Side 17