Pitney Bowes DM925 - Manual (Page 16)

1 • Read This First
1 - 6 SV62207 Rev. B
• Be certain the area in front of the wall receptacle into which the machine
is plugged is free from obstruction.
• To prevent overheating, do not cover the vent openings.
• Read all instructions before attempting to operate the equipment.
• Use this equipment only for its intended purpose.
If your stacker has an AC adapter to power the stacker:
• Use only the AC adapter designed specifically for the stacker and
shown in Chapter 11, Supplies and Options. Third-party AC adapters
may damage the stacker.
• To protect against electrical shock, plug the AC adapter power cord into
a properly grounded wall outlet.
Do not route the AC adapter cable over sharp edges or trap it between
furniture.
Your DM Series™ Digital Mailing System is designed to remain powered on
at all times. This is necessary so that the printer station can perform the
required maintenance it needs to maintain peak performance.
Your DM Series™ System has a power switch (for the location, refer to
Chapter 2
of this guide) so that you can properly remove power to the sys-
tem.
If you need to power off your system, you must use the power switch. When
you power off the system, the system immediately moves the printhead
back to the capping station to keep the printhead from drying out.
Powering off your system by any other means, such as a wall switch, a
power strip, or unplugging from a wall outlet, will result in higher than normal
ink consumption and could damage your mailing system.
NOTE:
Always follow the specific occupational safety and health standards
for your workplace.
Important Information About Powering Off
Your DM Series™ Digital Mailing System
NO NO NO
YES
OFF
ON