Pitney Bowes DM925 - Manual (Page 27)

DM925™ Digital Mailing System Operating Guide
SV62207 Rev. B 2 - 11
Connectors on the Back of the IntelliLink® Control Center
• Internal Analog Phone Line Connector - The IntelliLink® Control
Center has an internal analog modem and can connect directly to an
analog phone line. The term analog phone line refers to a RJ11C or
RJ11W compatible (single line) telephone wall plug typically used for a
residential phone or facsimile hookup.
• IntelliLink® Control Center AC Adapter Receptacle - The receptacle
for the AC adapter is located on the back of the IntelliLink® Control
Center. If you need to remove the control center from the mailing sys-
tem base and move it to an analog telephone line, you plug the AC
adapter into this receptacle. When the control center is connected to
the mailing system base, access to the AC adapter is blocked as indi-
cated by the dotted line in the picture below.
IntelliLink ® Control Center installed on a DM Series ™ System base. Dotted
line indicates AC Adapter Receptacle is covered by base
Analog Phone Line
Connector (on base)
Use this to connect
directly to an analog
phone line