Pitney Bowes DM925 - Manual (Page 84)

5 • Mailing System Setup
5-18 SV62207 Rev. B
Configuring
System
Timeouts This section describes how to set various
system timeouts for your mailing system.
1. To access the system timeouts, press
the Menu key on the control center, and
select Set Up.
2. Select Basic Settings and then Time-
outs
to get all of the timeout options.
The timeout options are listed on the right.
All of these options are described in the fol-
lowing sections.
Standby Mode: Least Power Usage
In order to reach the lowest level of power consumption, the mailing system
can be manually switched "Off" while still plugged into the wall. Toggle the
"On/Off" switch to "Off" when not using the mailing system for an extended
period of time. When switched back "On" expect some delay for a normal
reboot to assure that the entire system is ready to go.
Timeouts:
Display Sleep This option allows you to specify how long the system can remain inactive
before the display turns off. You can set the timeout for 1 - 30 minutes, in 1
minute increments. The default timeout is 5 minutes.
The display turns on again when you press any key on the control center or
if you place mail in the feeder or on the scale (either integrated or attached
external scale).
1. Press the Menu key and select Set Up.
2. Select Basic Settings and then Timeouts.
3. Select Display Sleep.
4. Enter the number of minutes (1-30) using the numeric keyboard.
5. Press the Enter key.
Timeouts: Sleep The "sleep" mode will save money, and help protect the environment. Use
this option to specify how long the system remains inactive before it goes
into "sleep".
You can set this timeout for 40 - 240 minutes, in 1 minute increments. The
default timeout is 10 minutes.
The system goes into display sleep before it goes into system sleep. The
system wakes up again when you press any key on the control center or if
you place mail in the feeder or on the scale (either integrated or attached
external scale).
1. Press the Menu key and select Set Up.
2. Select Basic Settings and then Timeouts.
3. Select System Sleep.
4. Enter the number of minutes (40 - 240 minutes) using the numeric key-
pad.
5. Press the Enter key.
12
Timeouts
 Display Sleep
 System Sleep
 Normal Preset Timer
 Feeding Timeout
 Transaction Timeout