Pitney Bowes DM925 - Manual (Page 48)

4 • Running Mail
4-16 SV62207 Rev. B
Mode Selection:
Time and Date
Stamping Time Date Stamping mode allows you to print the current time and date,
along with the word “Received” on incoming mail.
The time and date will remain the same during a single transaction
(whether you process a single envelope or 100 envelopes.) The system will
update the date and time during the mail run.
1. Press the Mode key.
2. Select Time and Date Stamping.
3. Turn the piece of mail over, so the meter stamp is facing down. Then,
place the envelope on the feed deck with the flap facing up.
4. Press the Start key. The Time/Date stamp prints on the envelope. A
sample Time/Date stamp is shown below.
5. Press the Start key. The Time/Date stamp prints on the envelope.
NOTE:
If you are using INIVEW™ Accounting, Time and Date Stamping mode
has additional attributes. Refer to “Selecting an Account in Time Date Stamping
Mode”
in Chapter 7 for more information.
NOTE:
The mailing system may operate at a slightly slower speed dur-
ing this process.
Date prints here (MMM DD YYYY)
Time prints here