Pitney Bowes DM925 - Manual (Page 31)

DM925™ Digital Mailing System Operating Guide
SV62207 Rev. B 3-3
4. Set the sealer lever. Push lever
to the right for sealing or to the
left for postcards and mail you
do not want sealed.
5. Use the thickness adjustment
knob to adjust for envelope
thickness.
• For thicker pieces of mail 
(3/8” to 5/8”), or mail contain-
ing several inserts, use the
thick mail setting. For most
mail under 3/8", use the nor-
mal mail settings.
• For large stacks of thin mail,
such as single inserts or post
cards, the thin mail setting
may be needed for better
performance. Refer to the
figure on the right.
To pick a setting, turn the knob to
the arrow located on the feed
cover.
Make sure you have sufficient funds in your postage meter. If the message
“Low Funds” appears on the screen, make sure you can complete the mail
run with the funds you have. If you do not have enough funds, see Chapter
6, Adding Postage
in this guide. uide and envelopes (about 1/16 inch clear-
ance).
6.
Running the
Mail 1. Press the Mode key on the IntelliLink® Control Center.
2. Select Key In Postage.
3. Key in the correct postage value using the numeric keys on the control
center, then press the Enter key.
Sealer
Lever
Normal Mail Setting
Thick Mail
Setting
Thin Mail
Setting
NOTE:
The “Auto-On” feature allows you to process mail without pressing the
start button after you place mail on the feed deck. The IntelliLink® Control Cen-
ter will advise you of the mailing stage you are in.