Altera Cyclone II EP2C35 PCI Development Board - Manual (Page 13)

Altera Corporation Core Version 4.0.0 2–3
May 2005 Cyclone II EP2C35 PCI Development Board Reference Manual
Board Components & Interfaces
User indicator User LEDs D1 through
D8 User configurable.
Power Power connector J2 External power supply connector.
Power
indicators +5.0-V power OK
LED D15 5.0-V power supply indicator.
+3.3-V power OK
LED D13 3.3-V power supply indicator.
+1.8-V power OK
LED D14 1.8-V power supply indicator.
+1.2-V power OK
LED D16 1.2-V power supply indicator.
Test points VREF TP4 VREF test point near VTT/VREF regulator.
Ground TP1 Ground test point near power connector.
TP2 Ground test point near PWR SWITCH.
TP3 Ground test point near MICTOR.
TP5 Ground test point near oscillator socket.
TP6 Ground test point near DDR2 SDRAM.
TP7 Ground test point near QDRII SRAM.
Expansion
interface Altera ® daughter
card (PROTO1)
J1, J6, J7 Interface to Altera daughter card (PROTO1).
I/O 10/100 Ethernet U3, RJ1,
OSC1 10/100 Ethernet MAC/PHY, RJ-45 connector,
25-MHz oscillator.
Serial I/O RS-232 U12, J12 RS-232 serial interface level shifter, DB9 connector.
RS-232 Tx LED D18 RS-232 transmitter active indicator.
RS-232 Rx LED D17 RS-232 receiver active indicator.
Debug Mictor probe J4 Mictor probe interface for Agilent logic analyzers.
Note to Table 2–1 :
(1) The Cyclone II EP2C35 PCI Development Board was designed to use either the EP2C35F672, EP2C50F672, or
EP2C70F672 device. However, the board ships with—and was only tested with—the EP2C35F672 device.
Table 2–1. Cyclone II EP2C35 PCI Development Board Components & Interfaces (Part 2 of 2)
Type
Component/
Interface
Board
Reference
Description