CIRCUTOR CVMk2 Series - Manual (Page 86)

86
CVM k2
DISPLA
Y
The following information is shown on the measurement system's information display screen.
The menus that appear above the function buttons are the following:
Exit : (F1) Use this button to exit the system information screens. Press this button to return to
the main measurement screen from which the current screen was accessed.
Med : (F2) System Information.
This button is used to display the measurement module configuration screen.
TEXT VALUE DESCRIPTION
M e a s u r e m e n t
number
01 / 01 Module number / total modules connected.
Version measured CVMk2-ITF-405-*** Module type and firmware version of the same.
Measurement name GENERAL Edited name for the measurement module.
S/N measured ************** Module serial number.
Prim. U 0000001 Primary for the programmed voltage transformer.
Sec. U 001 Secondary for the programmed voltage transformer.
Prim. I 00500 Primary for the programmed current transformer.
Prim. In 00005 Primary for the programmed neutral line current
transformer.
Sec. I 5 Secondary for the programmed current transformer.
Card 1 NONE*********- No card is detected in slot 1.
Card 2 EXP-DIG-8I/4O 1.0 Digital inputs/relay outputs card detected.
Card 3 EX-μSD/ETHERNET
1.0
μSD memory and Ethernet card detected.
The menus that appear above the function buttons on this screen are the following:
Exit : (F1) Use this button to exit the system information screens. Press this button to return to
the main measuring screen from which the current screen was accessed.
Disp : (F2) Press this button to return to the previous screen where the display screen
configuration parameters are shown.