CIRCUTOR CVMk2 Series - Manual (Page 94)

94
CVM k2
DISPLA
Y
6.1.4.1. Current waveform display
The current waveform is displayed on this screen. The up/down arrow buttons can be used to
navigate inside the screen to select or deselect each one of the L1, L2 and L3 phases.
Upon accessing the screen, the cursor is situated over L1 and is activated by default. To view
the other phases, place the cursor over the desired phase and press
SET . If the phase selected
was already activated, pressing SET will deactivate it.
Accordingly, the three waveforms on the three phase line can be simultaneously viewed. They
can also be grouped according to preference.
The boxes situated on the right side of the screen, which correspond to each phase, provide
the RMS value of the current for each one of the phases.
WARNING: Refreshing screens that display graphics such as waveforms and
phasors takes one second. If there is any event that last less than one second
or that is not cyclic, it will not be displayed.
The menus that appear above the function buttons on this screen are the following:
z hx1: Horizontally zoom in on the waveform displayed. This is a cyclic zoom with x1, x2 and x4
options, which then returns to normal.
z vx1: This button can be pressed to vertically zoom in on the waveform displayed. This is a
cyclic zoom with x1, x2, x4 and x8 options, which then returns to start.