CIRCUTOR CVM144 Series - Manual (Page 56)

----- Supply network analyzer CVM-144 ------ User's manual --- Page No. 55
b.- SETTING COMMUNICATION PARAMETERS
SET
Cdef Default configuration
NO "max" key to switch from NO / YES
• If YES is chosen: the configuration is 001 / 9600 / 8 bits / N / 1 bit
• If NO is chosen, pressing " " following options successively appear:
- n PER : Peripheral No. 001 to 255
- Baud 1 : baud rate 1.200 – 2.400 – 4.800 – 9.600 – 19.200
- Parity : No, even, odd
- LEN : (length) 8 bits
- Stop bits : 1 or 2
12.2.- SET-UP locking or unlocking
SET
Up
Unlo
Loc (locked SET-UP) or Unloc (unlocked SET-UP)
Use the key "max" to modify the choice.
- Whether LOC is set, when the SET-UP is accessed, configuration
parameters can be visualized but cannot be modified.
- To modify the previously set option, a 4-figure password is required to be
entered (in case that this password is not correct, this blinks and the previous
menu is again accessed).
PASSWORD : 1234
To exit this set-up mode, the key RESET can be pressed at any moment
(WARNING: if the set-up is exited by pressing the key RESET some last
modifications might not be saved in memory) or reach the end of this set-up mode.