CIRCUTOR AR5L Series User Manual
Page 20
20
4.8.- Recharging the analyzer battery
The analyzer is equipped with an intelligent energy charging system. This
means that the instrument continuously checks in an automatic way the state of the
battery, thus the charging process stops when the battery is at its maximum charge
level. The span life of the battery is so increased.
To enable the battery charging proceed as follows:
• Connect the power supplier set to the main.
• Connect the analyzer to the power supplier set.
• Turn the analyzer on by pressing button [ON].
Provided the analyzer is connected to the main through the power supplier set,
the battery is self-recharging.
If the battery is exhausted, the charging process should last at least 3 hours
with no interruption; although a charging period of 16 hours is advisable in order to
completely charge the battery.
The analyzer shows on screen a battery charge indicator:
NOTE: The battery charge is only used while the ANALYZER is turn on.
4.9.- Energy saving
The ANALYZER has an energy saving system. So, if no key is pressed for at
least 5 minutes, the display is automatically off. The analyzer continues the recording
data process but nothing appears on display.
The display will automatically be active when any key is pressed (excepts for
the key [ON] that causes no effect).