Cutting mode – Argox F1 User Manual
Page 43
Advertising
43
Cutting Mode
Note:
For cutting mode you must first install the cutter
—please refer to
Appendix A.
Follow steps 1 to 6 in
“Loading Media – Standard Mode” above and then
continue with the steps below.
7. Thread the media over the platen roller, and then route the media through
the slot of the cutter module. (Figure 15)
Figure 15
8. Press down the print head module firmly.
9. Turn on the printer or press the
“FEED” button if the printer is already on.
(Figure 16)
Advertising