Argox F1 - Manual (Page 55)

55
1 (CENTER)
Sensor 1 is positioned in the center of the
media route. This option enables sensor 1.
2 (LEFT) The position of sensor 2 is to the left side of
sensor 1. This option enables sensor 2.
MEDIA CAL LENGTH Set the maximum label length to calibrate.
12 INCH (1~30) The default media calibration length is 12
inches.
MEDIA CALIBRATION Calibrate and detect media gap. Press
<Enter> to activate this operation.
PRINT MODE Setup label removal method. The method
you select must correspond to the print
mode. Press the up <
↑> and down <↓>
buttons to scroll through the selection.
NORMAL
TEAR OFF This parameter establishes the position of
the labels over the tear-off bar after printing.
PEEL OFF Enables label peeler mode.
CUT The printer automatically cuts a label after it
is printed.
BY COMMAND
Sets a specific number of labels for cutting by
command.
CUT AFTER
BATCH
The printer waits to cut after the number of
labels you set in BATCH COUNT.
BATCH COUNT
0001 (1~9999) Sets the number of labels for BATCH CUT.
BATCH CUT The printer waits to cut after the number of
labels you set with “P” command to the
printer.
SINGLE CUT Sets cut after one label