Ystem, Basic setup – Argox F1 User Manual
Page 54
54
Menu System
The menu system lets you set printer options using the buttons on the control
panel. The following is a description of menu selections and settings.
Basic Setup
Press <MENU> to enter Basic Setup Mode
Note: A checkmark indicates the default option.
RIBBON
This parameter sets print mode for use with
direct thermal (DT) or thermal transfer (TT)
mode. Press the up <
↑> and down <↓>
buttons to scroll through the selection.
YES
This option sets as the printer to TT mode.
NO
This option sets as the printer to DT mode.
MEDIA TYPE
This parameter shows the type of media you
are using. Press the up <
↑> and down <↓>
buttons to scroll through the selection.
Gap/Notch
Select for non-continuous web media,
non-continuous fanfold media, and tags.
GAP LENGTH
10mm (10~99)
Selects the gap length of labels.
MARK
Non-continuous black mark lines.
MARK
THICKNESS
10mm (10~99)
Select black mark thickness of labels
CONTINUOUS
Select for media without gaps or divisions
between labels.
TRANSMISSIVE
Select transmissive sensor 1 or 2. Press the
up <↑> and down <↓> buttons to scroll
through the selection.