Argox F1 - Manual (Page 59)

59
HEX DUMP The hex dump mode is a troubleshooting tool
for checking the interconnection between the
printer and the host computer. Select “ON”
and all transmitted data is dumped and
printed as ASCII and Hex values.
OFF Normal operating mode.
ON Prints raw ASCII data received from the host.
SERIAL COMM. Sets serial port communication.
Baud Rate
Determines the RS-232 baud rate.
9600bps
(1200~115200bps)
The default baud rate is 9600bps.
PARITY The parity of the printer must match the parity
of the host computer for accurate
communications to take place.
None
No parity.
Odd Odd parity.
Even Even parity.
DATABITS Set the Data Bit to match the setting used by
the host computer.
7Bits Seven bit Word length.
8Bits
Eight bit Word length.
STOPBIT Define Stop Bit.
1 One stop bit.
2 Two stop bits.
HANDSHAKE Define handshake protocol between printer
and host.
BOTH Use both handshaking methods.
XON/XOFF
CTS/RTS
FINE DARKNESS Fine-tunes darkness based on current main
darkness level.
0 (-63~+63) The default fine darkness is 0.
BASE SPEED Sets the base print speed. The real print
speed is main speed plus base speed.