Argox F1 - Manual (Page 79)

79
All other times use the following procedure:
1. Put the media end on the roller.
2. Close the TPH latch.
3. Turn on the printer.
4. Press the FEED button so the media end goes through the cutter.
The cutter generally cuts the label at the center of the media gap. You may
change the cutting position for special media by operating the panel setting or
sending a shift command to the printer:
Panel setting:
1. Enter the panel setting menu and choose OFFSET item.
2. Use the up and down keys to select the CUT OFFSET option.
3. Save and exit the menu setting after selecting a suitable cut offset.
4. Feed a label and cut it off.
5. Repeat the procedure if the cutting position is still incorrect.
Sending a shift command:
You may send a shift command. <ESC>KI;
where “-“ is a signed byte and in terms of dots. This parameter can be
saved permanently in the EEPROM.