ARRIS SBM1000 User Guide - Manual (Page 26)

Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 18
590631-001-a
Figure 14 – Room 1: SBM1400 Adapter Installation
6. Connect one of the Ethernet cables (included) to one of the Ethernet ports on the SBM1400
and the Ethernet/Network port on your Smart TV or other Smart device (see Figure 14).
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.
7. Connect one of the power adapters (included) to the Power port on the SBM1400 and plug it
into an electrical wall outlet (see Figure 14).
8. If needed, install the SBM1100 to support a second Smart TV installation in your home (see
Room 3 in Figure 13).
Note:
Installations that have integrated MoCA gateways do not require a second SBM1000
adapter (see Room 2 in Figure 13). The second SBM1000 adapter can be used to enable a
second room on the MoCA network (see Room 3 in Figure 13).
9. Disconnect the coaxial cable from your Smart TV or set-top box and connect it to the IN
connector on one of the RF splitters (included).
10. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1100 and
one of the OUT connectors on the RF splitter (included).
Note
: You can use either OUT connector on the RF splitter (included) for this installation.
11. Connect another coaxial cable (included) to the Coax connector on the Smart TV or set-top
box and the other OUT connector on the RF splitter (included).
12. Connect one of the Ethernet cables (included) between the Ethernet port on the rear of the
SBM1100 and the Ethernet/network port on your Smart TV or other networked audio-visual
device.
13. Connect one of the power adapters (included) to the Power port on the SBM1100 and plug it
into an electrical wall outlet.
ο The Coax LEDs on both MoCA adapters should turn ON within five minutes to indicate
that a secure coaxial link was established between the two adapters.
ο If the Coax LED does not turn ON within five minutes, disconnect the power adapter
from both MoCA adapters and then reconnect them, if the Coax LEDs still fail to turn
ON, see Troubleshooting Solutions for more information.