ARRIS SBM1000 User Guide - Manual (Page 30)

Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 22
590631-001-a
You can now configure your Smart TV and other Ethernet-enabled devices for Internet access
through their related user interfaces.
See
Configure_MoCA_Adapters for more information on setting up the MoCA adapters.
2.2 Installing for AT&T U-verse with AT&T Gateway-Integrated
Modem & Router
Figure 18 – Room 1: AT&T U-verse Installation with Gateway
1. Identify the rooms that you want to add to your home network and make sure there is a
coaxial cable connection in each room.
2. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the first room (see
Room 1 in Figure 18).
Note
: Although the SBM1100 and SBM1400 adapters are interchangeable, the SBM1400 is
typically located where more than one Ethernet connection is required (see Room 1 in Figure
18).
3. Check if the coaxial cable is connected to an RF splitter. If it is not, then disconnect it from
your Smart TV or set-top box and connect it to the IN connector on one of the RF splitters
(included).