ARRIS SBM1000 User Guide - Manual (Page 28)

Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 20
590631-001-a
2.1 Installing for AT&T U-verse with a Separate Wi-Fi Router
Figure 16 – AT&T U-verse Installation with Separate Wi-Fi Router
1. Identify the rooms that you want to add to your home network and make sure there is a
coaxial cable connection in each room.
2. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the first room (see
Room 1 in Figure 16).
Note
: Although the SBM1100 and SBM1400 adapters are interchangeable, the SBM1400 is
typically located where more than one Ethernet connection is required (see Room 1 in Figure
16).
3. Check if the coaxial cable is connected to an RF splitter. If it is not, disconnect the cable from
your Smart TV or set-top box and connect it to the IN connector on one of the RF splitters
(included).
4. Connect one of the coaxial cables (included) to the OUT connector on the RF splitter and the
Coax In connector on the SBM1400 (see Figure 17).
Note
: You can use either OUT connector on the RF splitter (included) for this installation.
5. Connect a second coaxial cable (included) to the other OUT connector on the RF splitter and
the coaxial connector on your Smart TV or set-top box (see Figure 17).