Artesyn ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) - Manual (Page 31)

Installation of ViewCheck
ViewCheck on ATCA-7470/7475 Installation and Use (6806800S49C) 31
You should install BSF RPMs in the following sequence:
1. ssf_main
2. ssf_csim
3. ssf_diagnosticsTLS
You can install the BSF using the following RPM commands:

rpm -iv --nodeps --force ssf_main_rel-<BLADE>-<DIST>-
<RELEASEBUILD>.<ARCH>.rpm
 rpm -iv --nodeps --force ssf_csim_rel-<BLADE>-<DIST>-
<RELEASEBUILD>.<ARCH>.rpm
 rpm -iv --nodeps --force ssf_diagnosticsTLS_rel-<BLADE>-<DIST>-
<RELEASEBUILD>.<ARCH>.rpm
You can uninstall the BSF using the following RPM commands:
 rpm -e ssf_diagnosticsTLS_rel-<BLADE>-<DIST>-
<RELEASEBUILD>.<ARCH>.rpm

rpm -e ssf_csim_rel-<BLADE>-<DIST>-<RELEASEBUILD>.<ARCH>.rpm
 rpm -e ssf_main_rel-<BLADE>-<DIST>-<RELEASEBUILD>.<ARCH>.rpm
After the installation, the BSF binary files are installed at the /opt/ssf location.
The BSF applications can be started, stopped and restarted using below script.
sh /opt/ssf/etc/config/S99SsfBsfRun.sh start/stop/restart
4.4 ViewCheck Service OS Image
The ViewCheck Service OS Image enables you to boot into ViewCheck specific OS and execute
the OOSD tests. The ViewCheck service is not completely dependent on the blade BBS
environment. For compatibility purpose, it may use the same OS or Kernel variant that are used
by the blade BBS service. For ATCA-7470/7475, the ViewCheck service OS is created with PNE
4.x as the OS.